+8618974971540

The specific use method and steps of the edge finder

May 22, 2021

Offset edge finder

1. Φ10 straight shank can be installed on cutting chuck or drilling chuck;

2. Gently press the side of the measuring cell with your finger to make it eccentric by 0.5mm;

3. Make it rotate at a speed of 400-600RPM;

4. The spring force is small, which can prevent small milling cutters or small drills from breaking;

5. Bring the probe into contact with the end face of the workpiece, touch and move little by little, and it will reach the full contact state. The probe will not vibrate, just as if it is in a static state. The child will shift out of position, and the starting point of sliding here is the required reference position;

6. The position of the end face of the workpiece itself is the coordinate position with the measuring sub-radius 5mm added.


Extended information:

The mechanical edge finder is a high-precision measuring tool that can quickly and easily set the precise center position of the mechanical spindle and the reference plane of the workpiece. The structure of the mechanical edge finder: the hollow upper and lower detection heads of the clamping part and the eccentric part, the springs that can penetrate the upper and lower detection heads, and the springs can be respectively hooked and fixed and embedded on the top and bottom of the upper and lower detection heads The top cover, bottom cover and other components of the end are combined.

The working principle of the mechanical edge finder: it is clamped on the machine tool and rotates at a low speed to automatically adjust the position of the machining center through eccentricity adjustment.


Send Inquiry