Alloy milling cutters are widely used in the processing field of large depth of cut and feed. It adopts advanced ultra-fine grain nano-coating technology and cooperates with a high-toughness gradient alloy matrix to provide excellent performance. It can be used in the process of large depth of cut, large feed, and high speed cutting. With cutting performance.
While the impact toughness of the alloy milling cutter is improved, the wear resistance is greatly improved. It is an ideal choice for steel finishing to semi-finishing high-speed cutting. The cutting speed can be increased by more than 25%. Under the same cutting speed, the tool life can be increased More than 30%. The alloy milling cutter adopts a thick coating, which has strong resistance to plastic deformation and edge strength. It is a general choice for steel from finishing to rough machining. Alloy milling cutters are suitable for finishing and semi-finishing of cast iron materials. They have good impact resistance and resistance to plastic deformation, as well as good impact resistance. They are suitable for finishing, semi-finishing and roughing of stainless steel.
In the machining process, when the tool needs to move between two points without cutting, pay attention to the following conditions. When it is set to raise the tool, the alloy milling cutter will advance to the safety plane and then move on the safety plane; otherwise, it will directly move between two points without lifting the tool. Direct movement can save the time of lifting the tool, but you must pay attention to safety. There should be no protruding parts in the movement path. Pay special attention to the programming. When the surface is selected for processing by area and processed by partition, whether the part that is not selected in the middle is higher than The part of the tool movement path. In rough machining, it is usually recommended to use the tool lift for larger area machining, so that the tool can be paused during machining and the tool can be checked. In finishing machining, it is often used without raising the tool to speed up the processing speed, especially for the processing of corners. Raising the knife will greatly extend the processing time.
When the alloy milling cutter vibrates, you should consider reducing the cutting speed and feed rate of the slitting circular insert. If both have been reduced by 40% and there is still greater vibration, then you should consider reducing the amount of tooling. Some foreign tool samples are attached with round insert cutting parameter selection table for reference. But there are two points to note:
①If you use ordinary machine tools to process, you should eliminate the gap of the feed mechanism; ②When the surface of the workpiece is left with an oxide film or other hardened layer formed by the casting or forging process, it is advisable to use up milling.
If an alloy milling cutter is used, because the tool deflection is large, it is easy to produce vibration and cause the tool to break. Vibration will make the end milling cutter's circumferential edge eat unevenly, and the cutting and expansion amount will be larger than the original value, which will affect the machining accuracy and tool life. Therefore, in the machining process, if only the cutting edges around the end of the alloy milling cutter are required to participate in the cutting, the total length of the tool should be longer than that of the long-shank end mill.





