+8618974971540

NC processing technology

Feb 28, 2023

NC processing technology
CNC machining mainly refers to the use of digital information recorded on the media to realize the control of the machine tool, thus automatically performing the required processing tasks. CNC processing can ensure that the products reach high processing accuracy and stable processing quality; Easy to automate the operation process; High production efficiency and short production cycle; It can greatly reduce process equipment and meet the needs of rapid product upgrading; It is usually closely connected with CAD Up to realize the transformation from design ideas to final products.
The link between the process and each step of the whole CNC process should be emphasized. Generally speaking, the whole process consists of product analysis - graphic design - process planning - path generation - path simulation - path output - processing - inspection.
1. Product analysis Through product analysis, certain composition information and some specific processing requirements can be obtained.
2. Graphic design Graphic design should first determine the type of graphics by analyzing the processing requirements based on the detailed analysis of the product, and then draw through the graphics software.
3. Process planning analyzes the appearance and processing requirements of prefabricated products, from the overall processing to the reasonable establishment of each processing step.
4. The process of path generation is actually realized by software, and the parameters of tool path setting are optimized to a certain extent.
5. The path simulation path generally affects the final performance of the machine after production, and the effect is not intuitive. Here, we can check the possible problems through path simulation, so as to reduce the actual waste rate. General inspection focuses on the appearance of the workpiece. Whether it is cutting or cutting, then whether the path of process planning is reasonable.
6. Path output Path output is a necessary step for software design and programming to realize the above in the machine. Two intermediate references can be created through path output. If you have a digital background, you can also interpret it as tool path post-processing.

Send Inquiry