turning tools
The cutting part of a turning tool consists of a main cutting edge, a small cutting edge, a rake face, a main rake face, a small rake face, and a cutting edge angle. The combination of the cutting part of the turning tool and the handle (i.e. the clamping part) mainly includes integration, welding, mechanical clamping, and welding mechanical clamping. Mechanically clamped turning tools can prevent stress and cracking of hard alloy blades during high-temperature welding, and the tool handle can be used multiple times. Mechanical clamping turning tools are usually mechanically clamped turning tools that use screws and pressure plates to clamp the blades, and are equipped with indexable blades. After passivation, the blade can be used for indexing and has a short parking time, resulting in rapid development.
The cutting part of a turning tool consists of a main cutting edge, a small cutting edge, a rake face, a rake face, and a small rake face. Its geometric shape is determined by the front corner γ o. Posterior horn α o. Principal declination κ r. Anterior horn γ S. Secondary declination κ R 'and tool tip arc radius r ε Decision. The selection of geometric parameters for turning tools is influenced by many factors and must be based on specific circumstances. Anterior horn γ O is selected based on the composition and strength of the workpiece material, and a smaller value should be taken when cutting materials with higher strength. For example, hard alloy turning tools are cutting
The rake angle of carbon steel is 10 ° to 15 °; When cutting chromium manganese steel or hardened steel, it requires -2 ° to -10 °. In general, the rear angle is between 6 ° and 10 °. Lead angle κ R is determined based on the rigidity conditions of the process system, generally ranging from 30 ° to 75 °, with a larger value taken when there is a difference in rigidity. When using a stepped axis, the cutting method needs to be greater than or equal to 90 °. Blade radius r ε And secondary deflection angle κ R 'is generally selected based on the requirements for surface roughness of the machined surface. Blade inclination angle γ S is determined based on the required chip removal direction and blade strength. The type of front part of the turning tool (Figure 2) is mainly determined by the properties of the workpiece material and tool material. The simplest type is the flat type, and the front shape of the front corner is suitable for precision machining with high-speed steel turning tools and hard alloy turning tools.
Contact Us
- Room 103, Building A25, Shuiyingjiazhou, Taiyangshan Road, Qingzhuhu Town, Kaifu District, Changsha, Hunan China
- cutoutil@hanvitools.com
- +8618974971540
turning tools
Jun 22, 2023
You Might Also Like
Send Inquiry





